Home > Knowledge > Content

How to add steel balls to ball mill

May 30, 2024

Ball mill steel ball is the ball mill equipment grinding material media, through the ball mill steel ball collision with the material, friction to produce grinding peeling effect. Ball mill work process, grinding body steel ball gradation is reasonable, related to the efficiency of the equipment, only to ensure that a variety of balls have a certain ratio, in order to adapt to the composition of the particle size of the material to be ground, to achieve a good grinding effect.  

 

1715674800039

 

Ball mill steel ball grading basic principles:

1, dealing with hardness, coarse size of the ore, need to have a greater impact, need to load a larger steel ball, that is, the harder the material, the larger the diameter of the steel ball;

 

2, the larger the diameter of the ball mill, the larger the impact, the smaller the diameter of the selected steel ball;

 

3, for double compartment partition, discharge cross-section of the same single compartment, the ball diameter should be smaller than the single compartment;

 

4, the general distribution of the ball has four levels, large ball less, small ball more, the middle of the ball big, that is, "less at both ends, more in the middle".

 

Ball mill steel ball ratio factors to consider:

1, equipment type, such as cylinder diameter, length, etc.;

 

2, the output requirements, that is, the user of the material grinding fineness standards;

 

3, the nature of the material, refers to the initial particle size of the grinding material, hardness, toughness and so on;

 

4, specification size, please pay attention to the size of the specification, not the pursuit of large specifications.

 

Ball mill steel ball adding skills: 

Ball mill steel ball ratio should be based on the effective length of your mill, whether it is equipped with a roller press, the size of the feed material, the liner and structure used, the expected fineness of the screen slag and the specific table, how many chrome balls are used, how many rotational speeds and other factors to comprehensively determine. After the ball mill is installed, you need to engage the large and small gears of the ball mill, and the processing capacity should be gradually increased, after two or three days of normal operation of the ball mill, check the large and small gears meshing, after everything is normal, start the ball mill, and the second time to add the remaining 20% of the steel balls.

 

 

 

 

Send Inquiry