Automatic mineral processing centrifugal concentrator machine is an important equipment in the modern mineral processing industry, which separates the ore efficiently and accurately by centrifugal force, so as to improve the grade and recovery rate of the ore. The following is a detailed introduction to the working principle and use of automatic mineral processing centrifuge.
Working Principle：
Automatic mineral processing centrifuge utilizes the centrifugal force generated by high-speed rotation to separate the useful minerals and veins in the ore. In the process of high-speed rotation, mineral particles of different densities will be subjected to different centrifugal force, heavy minerals due to the larger centrifugal force and deposited on the inner wall of the drum, and rotate with the drum; light minerals due to the smaller centrifugal force, in the process of rotating at a certain helix angle from the feed end of the drum along the direction of the slope of the drum to the discharge end of the flow, and ultimately discharged into the tailings.
This separation method is characterized by high efficiency and accuracy, and can significantly improve the grade of the ore. In addition, some advanced automatic centrifuges for ore dressing also incorporate features such as backwash pressure water to overcome the defects of the traditional centrifugal concentrator in the process of ore dressing due to the decline in the recovery rate of ore dressing caused by the slattern of the ore layer.
Usage:
The use of automatic centrifugal concentrator is relatively simple, but before operation, you need to make sure that you have read and understood the instruction manual of the equipment in detail, and strictly follow the operating procedures. The following are the basic steps:
1. start-up preparation: ensure that the centrifuge is placed on a flat, stable ground, check whether the components are intact, and make sure that the power connection is normal.
2. Load minerals: Open the centrifuge door cover, select the appropriate rotor and adapter, and clean the rotor, centrifugal chamber and adapter. Place the minerals to be separated evenly inside the rotor.
3. Set parameters: Close and lock the centrifuge door cover and plug in the power supply. According to the mineral characteristics and separation requirements, set the appropriate speed, time and other parameters on the control panel.
4. Start centrifugation: After confirming all the settings are correct, press the "start" button and the centrifuge starts to work. In the process of centrifugation, pay attention to observe the running status of the equipment, if there is any abnormality, it should be shut down in time for inspection.
5. Collect the product: after centrifugation is completed, wait for the equipment to stop running completely and then open the door cover, take out the rotor and collect the separated minerals. Pay attention to hold and put down gently to avoid damaging the equipment or products.
6. cleaning and maintenance: after use, clean the centrifuge parts in time, and carry out the necessary maintenance and repair work to ensure the long-term stable operation of the equipment.
Automatic mineral processing centrifuge with its high efficiency and automation, plays an increasingly important role in the mineral processing industry. With the continuous progress of science and technology and the depth of the application, I believe that the automatic centrifuge will play a greater role in the future of mineral processing.
